Laser/Experiments: Unterschied zwischen den Versionen

aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen
(→‎about: added leather, new material)
Zeile 14: Zeile 14:
** engraving a soap ended in the soap swelling,  or so I’ve heard.
** engraving a soap ended in the soap swelling,  or so I’ve heard.


* Leather
** Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 100, Power: 60, Frequency:500Hz
** Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather


== ideas ==
== ideas ==

Version vom 28. Juni 2011, 16:39 Uhr

about

This section explores different possibilities of parameters and their outcome. This is a good place to get you an idea on how to fine tune your parameters.

Material:

  • The material
    • different parameters 1
    • different parameters 2
    • different parameters 3
  • Soap
    • engraving a soap ended in the soap swelling, or so I’ve heard.
  • Leather
    • Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 100, Power: 60, Frequency:500Hz
    • Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather

ideas

  • making a example raster / vector file for experimental cuts
    • using color mapping for different speed/power/frequency in one job..