Embedded Tor Node: Unterschied zwischen den Versionen
Pepi (Diskussion | Beiträge) K →wording |
Pepi (Diskussion | Beiträge) |
||
| Zeile 62: | Zeile 62: | ||
* Indicate status information with two of the three LEDs on the board | * Indicate status information with two of the three LEDs on the board | ||
* Management GUI? | * Management GUI? | ||
=== Pictures of a Finished Tor Node === | |||
[[Bild:Embedded_Tor_Node1.jpg]] | |||
The components for the device. | |||
(From top left to bottom right) | |||
enclosure bezel with cutting for USB ports | |||
logic board (ALIX 3D2) | |||
enclosure bezel with cuttings for: WiFi Antenna (not used in this project), RJ45 (ethernet), power jack, 2nd antenna, 3 LEDs, RS232 serial | |||
green passive processor cooler (optional), 2GB Compact Flash card (SanDisk) | |||
Aluminum enclosure | |||
Power Supply with Euro plug. | |||
The assembled device looks like this: | |||
[[Bild:Embedded Tor Node2.jpg]] | |||
Backside view with two USB 2.0 ports | |||
[[Bild:Embedded Tor Node3.jpg]] | |||
Frontside view with RJ45 (ethernet), power jack, RS232 serial connector The LED (green) cuttings are below the right antenna plug. The holes for optional WiFi antennas have been protected with rubber plugs. | |||
=== Thanks === | === Thanks === | ||
Thanks to [[User:kyrah|kyrah]] for her mental support during times of hair pulling struggle and worldi on ##FreeBSD for sharing his knowledge about FreeBSD package management and the nanoBSD build process. Also thanks to all the folks who wrote documentation about nanoBSD. | Thanks to [[User:kyrah|kyrah]] for her mental support during times of hair pulling struggle and worldi on ##FreeBSD for sharing his knowledge about FreeBSD package management and the nanoBSD build process. Also thanks to all the folks who wrote documentation about nanoBSD. | ||