3d printer workshop: Unterschied zwischen den Versionen
aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen
Keine Bearbeitungszusammenfassung |
(→When?) |
||
| Zeile 12: | Zeile 12: | ||
! Name | ! Name | ||
|- | |- | ||
| | | Harald | ||
|- | |- | ||
| free slot | | free slot | ||
| Zeile 84: | Zeile 84: | ||
! epty | ! epty | ||
|} | |} | ||
== Time Table == | == Time Table == | ||
Version vom 20. November 2022, 12:21 Uhr
3D Drucker Workshop
Because of the interest in learning about 3d printing I (BadPractice) decided to do a workshops.
When?
- 23. 11. 2022 19:00
Participants (8 slots)
| Name |
|---|
| Harald |
| free slot |
| free slot |
| free slot |
| free slot |
| free slot |
| free slot |
| free slot |
- 25. 11. 2022 19:00
Participants (8 slots)
| Name |
|---|
| free slot |
| free slot |
| free slot |
| free slot |
| free slot |
| free slot |
| free slot |
| free slot |
- 30. 11. 2022 19:00
| Name |
|---|
| free slot |
| free slot |
| free slot |
| free slot |
| free slot |
| free slot |
| free slot |
| free slot |
- Date suggestions
| epty |
|---|
Time Table
| Time | Topic | Importance |
|---|---|---|
| 15 min | Where to get 3d models | recommended |
| 30 min | Slicing | core |
| 30 min | Start a print hands on (changing filament and z- leveling) | core |
| 10 min | Overhangs, Bridges and Support | recommended |
| 10 min | Different materlials | recommended |
| 5 min | 3D Benchy | optional |
| 20 min | Break | |
| 20 min | Troubleshooting | optional |
| 30 min | Cold pull | optional |
| 20 min | advanced calibration | optional |
| 10 min | maintenance | optional |
| 30 min | swapping a nozzle | optional |
| 10 min | current development | optional |
