Witbox: Unterschied zwischen den Versionen

← Zum vorherigen Versionsunterschied Zum nächsten Versionsunterschied →

VisuellWikitext

@@ Zeile 28: / Zeile 28: @@
 Material: PLA only
-Firmware version: ???
+Firmware version: 1.4.2 ( 29.10.2015)
 This machine was sponsored (better price) from [http://www.3dee.at/ 3dee.at]
 ===How to use it===
-Calibration (before every job @ metalab)
+'''Calibration (before every job @ metalab)'''
+- There is a calibration sheet inside the witbox.
+- Calibration is simple. Just follow the instructions on the menu.
+- Configuration -> Level plate
-Load / Change Filament if neccessary  - Careful not to entangle the filament!!
+'''Load / Change Filament if neccessary  - Careful not to entangle the filament!!'''
+- To cahnge or unload the filament select the matching option from the menu
+- very gently apply some pull to the filament and you will feel that the filament is actually pulled for extraction first and after some seconds it is ejected
+- Once the filament is eject apply some more pullign force
+- when the filament comes loose pull sharply and remove the filament from the tube completely (also any long debris that might hang off the filament needs to get out)
-Save your .gcode to the SD card
-Start job from menu.
+'''Save your .gcode to the SD card'''
+- Start cura
+- Import .stl
+- Save to SD
+- Done.
+'''Start job from menu'''
+- Select "Print from SD"
+- Select your job
+- Push  dialing wheel- > job starts
@@ Zeile 104: / Zeile 118: @@
 ===TODOs===
+List of things we COULD do.
+'''ANY MODIFICATION NEEDS CONSENS BEFORE BEING APPLIED!!!
+DO NOT CHANGE ANYTHING UNLESS WE ALL AGREE ON IT FIRST (jour fixe)'''
 Setup raspberry pi with octoprint
@@ Zeile 110: / Zeile 130: @@
 Mount camera
+Add a white ledstrip
+Add a switch to disable the ventilation