Witbox: Unterschied zwischen den Versionen
Keine Bearbeitungszusammenfassung |
Keine Bearbeitungszusammenfassung |
||
| Zeile 12: | Zeile 12: | ||
__TOC__ | __TOC__ | ||
=== | ===Overview=== | ||
Filament diameter 1.75mm | Filament diameter 1.75mm | ||
Layer height: 0.05-0.25 mm (0.2 is fast and looks good) | Layer height: 0.05-0.25 mm (0.2 is fast and looks good) | ||
Firmware version: ??? | |||
===How to use it=== | |||
Calibration | |||
Load / Unload Filament | |||
Insert a spool | |||
Careful not to entangle the filament!! | |||
===TODOs=== | |||
Setup raspberry pi with otoprint | |||
design camera mount | |||
mount camera | |||
===Policies== | |||
===Policies=== | |||
It is OK to use the printer as it is. | It is OK to use the printer as it is. | ||
| Zeile 24: | Zeile 51: | ||
This is a consumer grade semi professional machine, if you want to tinker with a 3d-printer check out the mendel90 reprap. | This is a consumer grade semi professional machine, if you want to tinker with a 3d-printer check out the mendel90 reprap. | ||
=== Software === | === Software === | ||
[http://www.bq.com/gb/support/witbox Cura for Witbox] | [http://www.bq.com/gb/support/witbox Cura for Witbox] | ||
=== Diverse Links === | === Diverse Links === | ||