CNC-Fräse/Technical: Unterschied zwischen den Versionen

aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen
Keine Bearbeitungszusammenfassung
Zeile 11: Zeile 11:
This aspect of a stepper motor means also: lower microstep setting allows higher speed and vice versa.
This aspect of a stepper motor means also: lower microstep setting allows higher speed and vice versa.


[[Datei:Steppertourque.png|400px]]
[[Datei:Steppertorque.png|400px]]

Version vom 8. Januar 2015, 20:13 Uhr

This page descibes technical aspects of the CNC machine in more detail.

Stepper Torque

The torque of a stepper driver is not linear over the number of revolutions per second. It is nearly linear in the beginning but drops down at a specific point for each motor until it reaches zero. In our current setup we use Sanyo Denki 103h7126-0740 Motors, which are linear until about 1000 to 2000 pulses/second. We are using 8 Microsteps, so the normal 200 steps per revolution (1.8 Degree step size) must be multiplied by 8, which gives 1600 steps per revolution. Now we can calculate the maximum speed for a axis by taking the maximum pulses/second and divide it by the steps needed per mm (266,6 on our machine): We need the factor 8 here because of the microstepping.

This aspect of a stepper motor means also: lower microstep setting allows higher speed and vice versa.

Steppertorque.png