Bandsaw: Unterschied zwischen den Versionen

Version vom 4. Mai 2015, 10:57 Uhr

The Metalab currently has 2 different Bandsaws. Both Bandsaws are from Joe since 2014-05-01_Jour_Fixe.

A bandsaw can be used to cut wood, metalls and plastics not only in straight lines, but also curved lines.

Check if band is correctly tightned (Do it with caution, because the band is very sharp and can easily injure you!)
- See Repair Guide otherwise...
Check if the band is OK
- See Repair Guide otherwise..
Adjust the upper band holder to the correct hight (It should be right about your workpiece)
Switch it on
Saw

Do not use the bedstop (Seitenanschlag), because the cut off piece can easily lock up there and press the band aside
A Bandsaw is a free-hand tool, mark you cut path and cut there instead of measuring on the machine
The band swings in every direction a few parts of a mm. Consider that while you are sawing!

There is a good guide how to correctly setup a bandsaw here: Bandsäge einstellen (German)

@@ Zeile 1: / Zeile 1: @@
-The Metalab currently has 3 different Bandsaws. Two Bandsaws are from Joe since [[2014-05-01_Jour_Fixe]].
+The Metalab currently has 2 different Bandsaws. Both Bandsaws are from Joe since [[2014-05-01_Jour_Fixe]].
 A bandsaw can be used to cut wood, metalls and plastics not only in straight lines, but also curved lines.
@@ Zeile 5: / Zeile 5: @@
 == Current Status ==
-* Green Saw (Joe): Band is broken, otherwise useable
+* Green Saw: Band is broken, otherwise useable
-* Blue Saw (Joe): Operational, but band is a little bit rusty
+* Blue Saw: Operational, but band is a little bit rusty
-* Blue Saw (Metalab): Upper and Lower Band holder is broken - not useable at all
 == How to Operate ==