Bandsaw: Unterschied zwischen den Versionen
Reox (Diskussion | Beiträge) Die Seite wurde neu angelegt: „The Metalab currently has 3 different Bandsaws. A bandsaw can be used to cut wood, metalls and plastics not only in straight lines, but also curved lines. ==…“ |
Reox (Diskussion | Beiträge) Keine Bearbeitungszusammenfassung |
||
| Zeile 1: | Zeile 1: | ||
The Metalab currently has 3 different Bandsaws. | The Metalab currently has 3 different Bandsaws. Two Bandsaws are from Joe since [[2014-05-01_Jour_Fixe]]. | ||
A bandsaw can be used to cut wood, metalls and plastics not only in straight lines, but also curved lines. | A bandsaw can be used to cut wood, metalls and plastics not only in straight lines, but also curved lines. | ||
== Current Status == | |||
* Green Saw (Joe): Band is broken, otherwise useable | |||
* Blue Saw (Joe): Operational, but band is a little bit rusty | |||
* Blue Saw (Metalab): Upper and Lower Band holder is broken - not useable at all | |||
== How to Operate == | == How to Operate == | ||
* Check if band is correctly tightned (Do it with caution, because the band is very sharp and can easily injure you!) | |||
** See Repair Guide otherwise... | |||
* Check if the band is OK | |||
** See Repair Guide otherwise.. | |||
* Adjust the upper band holder to the correct hight (It should be right about your workpiece) | |||
* Switch it on | |||
* Saw | |||
=== General Tips === | |||
* Do not use the bedstop (Seitenanschlag), because the cut off piece can easily lock up there and press the band aside | |||
* A Bandsaw is a free-hand tool, mark you cut path and cut there instead of measuring on the machine | |||
* The band swings in every direction a few parts of a mm. Consider that while you are sawing! | |||
== How to Repair == | == How to Repair == | ||
There is a good guide how to correctly setup a bandsaw here: [http://www.1-2-do.com/forum/bandsaege-richtig-einstellen-thema-14087.html Bandsäge einstellen (German)] | |||
Version vom 10. Juni 2014, 09:31 Uhr
The Metalab currently has 3 different Bandsaws. Two Bandsaws are from Joe since 2014-05-01_Jour_Fixe.
A bandsaw can be used to cut wood, metalls and plastics not only in straight lines, but also curved lines.
Current Status
- Green Saw (Joe): Band is broken, otherwise useable
- Blue Saw (Joe): Operational, but band is a little bit rusty
- Blue Saw (Metalab): Upper and Lower Band holder is broken - not useable at all
How to Operate
- Check if band is correctly tightned (Do it with caution, because the band is very sharp and can easily injure you!)
- See Repair Guide otherwise...
- Check if the band is OK
- See Repair Guide otherwise..
- Adjust the upper band holder to the correct hight (It should be right about your workpiece)
- Switch it on
- Saw
General Tips
- Do not use the bedstop (Seitenanschlag), because the cut off piece can easily lock up there and press the band aside
- A Bandsaw is a free-hand tool, mark you cut path and cut there instead of measuring on the machine
- The band swings in every direction a few parts of a mm. Consider that while you are sawing!
How to Repair
There is a good guide how to correctly setup a bandsaw here: Bandsäge einstellen (German)