PCB CNC: Unterschied zwischen den Versionen
| Zeile 14: | Zeile 14: | ||
Some results are given in the soup of the [http://geilomat.soup.io/ Geilomat] | Some results are given in the soup of the [http://geilomat.soup.io/ Geilomat] | ||
* 0805 SMD resistors work fine, although the solder locations are not visible any more. | |||
* It is possible to have one wire between the 2.54mm piched pins. | |||
* Also 1.27mm pitch SMD chips are usually ok. | |||
* If you change the diameter of your vias to 0.8, you can use the 0.6 inner diameter "Kupferhohlnieten". if you have a double side-connected pin of you 0.8 mm you might want to use a 1mm hole, to use the larger "hohlnieten", where you can then insert a 0.8mm pin. | |||
===Time Consumption=== | ===Time Consumption=== | ||