Laser/Experiments: Unterschied zwischen den Versionen
Chrysn (Diskussion | Beiträge) Linking to test file used with parameters |
|||
| (2 dazwischenliegende Versionen von 2 Benutzern werden nicht angezeigt) | |||
| Zeile 24: | Zeile 24: | ||
** Cutting: Speed 90%, Power 20% | ** Cutting: Speed 90%, Power 20% | ||
** Engraving: more experiments to be done, but note: large black areas will melt the material deeply, thin lines will result in very betauful printing on the material (I used red felt, engraving on dark/brown/black felt might not make much sense) | ** Engraving: more experiments to be done, but note: large black areas will melt the material deeply, thin lines will result in very betauful printing on the material (I used red felt, engraving on dark/brown/black felt might not make much sense) | ||
* Jeans / Denim | |||
** engraving: 60% speed, 60% power. | |||
** engraving of denim glued onto wood: 60% speed, 100% power gets almost through the cloth and makes the wood partially visible. | |||
** cutting of denim glued onto wood: just cut a bit slower than through the wood alone (e.g. 15% speed instead of 20% speed) | |||
== ideas == | == ideas == | ||
* making a example raster / vector file for experimental cuts | * making a example raster / vector file for experimental cuts | ||
** using color mapping for different speed/power/frequency in one job.. | ** using color mapping for different speed/power/frequency in one job. One example is [[:Datei:slowdowntest.svg]], see also [[Laser/Parameters#Notes on engraving vector lines]]. | ||
== settings for circuit boards == | |||
* montana black 312g net/11 oz. blue spray paint use speed 50%, power 100% and 5000hz | |||
[[Kategorie:English]] | [[Kategorie:English]] | ||
[[Kategorie:Lazzzor]] | [[Kategorie:Lazzzor]] | ||