GoCNC: Unterschied zwischen den Versionen
Reox (Diskussion | Beiträge) Keine Bearbeitungszusammenfassung |
Pk (Diskussion | Beiträge) Sachdienliche Hinweise bitte an… |
||
| (3 dazwischenliegende Versionen von einem anderen Benutzer werden nicht angezeigt) | |||
| Zeile 4: | Zeile 4: | ||
|image=GoCNC A4Advanced.jpg | |image=GoCNC A4Advanced.jpg | ||
|owner=Metalab | |owner=Metalab | ||
|status= | |status=Gone? Pls direct pointers on whereabout to cnc list or [[Datei:Core.png]] | ||
|requirestraining= | |requirestraining=yes | ||
|requiresauth=NOPE | |requiresauth=NOPE | ||
|cost=900€ | |cost=900€ | ||
| Zeile 22: | Zeile 22: | ||
* Maximum Speed: around 1000mm/min | * Maximum Speed: around 1000mm/min | ||
* For use with Dremel or Proxxon Device as spindle | * For use with Dremel or Proxxon Device as spindle | ||
* It uses M10 threaded rods, which are quite bad... | * It uses M10 threaded rods, which are quite bad... | ||
* You can not put too much torque on the screws that hold the Z axis on the X axis - therefore the axis is not very stable. | |||
** If you fix the axis, the axis will be locked! | |||
== Configuration == | == Configuration == | ||