SMD-Stencils selber machen: Unterschied zwischen den Versionen
K whitespace fix |
Keine Bearbeitungszusammenfassung |
||
| (2 dazwischenliegende Versionen von 2 Benutzern werden nicht angezeigt) | |||
| Zeile 17: | Zeile 17: | ||
** Doubleclick on Layer 31 (tCream) | ** Doubleclick on Layer 31 (tCream) | ||
** Change Fillstyle to empty | ** Change Fillstyle to empty | ||
| Zeile 35: | Zeile 35: | ||
* Print | * Print | ||
* Print to file (PDF) | * Print to file (PDF) | ||
* Scale factor: 1 | |||
Import the .pdf into Corel draw and you are good to go. | |||
===Alternative Steps=== | |||
Import the | # Enable the dimension | ||
# Import the PDF to Inkscape | |||
# Disable strokes for all pads! | |||
# Save as SVG | |||
# Import to CorelDraw | |||
# Make sure the dimension fits | |||
# Cut! | |||
== Ze actual cutting == | == Ze actual cutting == | ||
| Zeile 45: | Zeile 55: | ||
You find this in my box in the WEL shelfes on the very right, next to the whiteboard. USe freely for stencils (but nothing else) | You find this in my box in the WEL shelfes on the very right, next to the whiteboard. USe freely for stencils (but nothing else) | ||
Place the overheadfoil on a piece of plain white copier paper and cut the stencil with an outline around the PCB | '''Place the overheadfoil on a piece of plain white copier paper and cut the stencil with an outline around the PCB''' | ||
Once you cut it you can remove the overheadfoil from the paper and all the little squers will stick to the paper. | Once you cut it you can remove the overheadfoil from the paper and all the little squers will stick to the paper. | ||