SMD-Stencils selber machen: Unterschied zwischen den Versionen
Keine Bearbeitungszusammenfassung |
|||
| (7 dazwischenliegende Versionen von 3 Benutzern werden nicht angezeigt) | |||
| Zeile 1: | Zeile 1: | ||
{{Head_en}} | {{Head_en}}{{Projekt | ||
{{Projekt | |||
|image=No-Logo.png | |image=No-Logo.png | ||
|involved=[[User:Overflo]] | |involved=[[User:Overflo]] | ||
| Zeile 10: | Zeile 7: | ||
|lastupdate= | |lastupdate= | ||
|hidden=false | |hidden=false | ||
}} | }}== This page contains Information on how to make a STENCIL for SMD paste == | ||
== This page contains Information on how to make a STENCIL for SMD paste == | |||
This Information is valid for all the electronic CAD programs but I will document how to do it in eagle. | This Information is valid for all the electronic CAD programs but I will document how to do it in eagle. | ||
| Zeile 22: | Zeile 14: | ||
* Open you .brd file | * Open you .brd file | ||
* Go to Layers Menu | * Go to Layers Menu | ||
* Disable ALL layers but Layer 31 (tCream) | |||
** Doubleclick on Layer 31 (tCream) | ** Doubleclick on Layer 31 (tCream) | ||
** Change Fillstyle to empty | ** Change Fillstyle to empty | ||
| Zeile 42: | Zeile 35: | ||
* Print | * Print | ||
* Print to file (PDF) | * Print to file (PDF) | ||
* Scale factor: 1 | |||
Import the .pdf into Corel draw and you are good to go. | |||
===Alternative Steps=== | |||
Import the | # Enable the dimension | ||
# Import the PDF to Inkscape | |||
# Disable strokes for all pads! | |||
# Save as SVG | |||
# Import to CorelDraw | |||
# Make sure the dimension fits | |||
# Cut! | |||
== Ze actual cutting == | == Ze actual cutting == | ||
Use Overheadfoil that can be used with a copier (than its not PVC) i got splendid results using [http://www.amazon.co.uk/NOBO-Transparency-Plain-Copier-sheets/dp/B000WL1WQI | Use Overheadfoil that can be used with a copier (than its not PVC) i got splendid results using [http://www.amazon.co.uk/NOBO-Transparency-Plain-Copier-sheets/dp/B000WL1WQI OHP Transparency film from NOBO] | ||
You find this in my box in the WEL shelfes on the very right, next to the whiteboard. USe freely for stencils (but nothing else) | |||
'''Place the overheadfoil on a piece of plain white copier paper and cut the stencil with an outline around the PCB''' | |||
Once you cut it you can remove the overheadfoil from the paper and all the little squers will stick to the paper. | |||
'''Cutter settings''' | '''Cutter settings''' | ||
* Speed: | * Speed: 100 % | ||
* Power: | * Power: 10 % | ||
* Hertz: | * Hertz: Vollgas. | ||
[[Kategorie:Howto]] | [[Kategorie:Howto]] | ||
[[Kategorie:Lazzzor]] | [[Kategorie:Lazzzor]] | ||
[[Kategorie:WhateverLab]] | |||
[[Kategorie:Projekte]] | [[Kategorie:Projekte]] | ||