HSC2011/Enclosure: Unterschied zwischen den Versionen

aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen
Keine Bearbeitungszusammenfassung
 
(3 dazwischenliegende Versionen von 2 Benutzern werden nicht angezeigt)
Zeile 3: Zeile 3:
__TOC__
__TOC__


 
== About the enclosure ==
The enclosure was designed and manufactured by [[Benutzer:Mazzo| mazzo]] using Blender and our makerbot "le giraffe"


== Files needed for the production of the enclosure ==
== Files needed for the production of the enclosure ==


* [[:Datei:Edubuzzer_stl_gcode.zip |  Gcode and STL files]] to feed your 3D printer omnomnomnom  
* All up to date files are found in the [https://github.com/Metalab/hsc2011/enclosure/ GIT repository] here is short summary of the important files
* [[:Datei:edubuzzer_middlepart.cdr | The middlepart for the lazzor]] You should cut this from 6mm acryl   
** [[:Datei:Edubuzzer_stl_gcode.zip |  Gcode and STL files]] to feed your 3D printer omnomnomnom  
* [[:Datei:EduBuZZer_Final.blend |  Blender file ]]
** [[:Datei:edubuzzer_middlepart.cdr | The middlepart for the lazzor]] You should cut this from 6mm acryl   
** [[:Datei:EduBuZZer_Final.blend |  Blender file ]]




Zeile 52: Zeile 54:
|-
|-
| valign="top"|[[Bild:Enclosure_rgb_inlay.JPG|thumb|400px|left|bottompart + middlepart + pcb ]]  
| valign="top"|[[Bild:Enclosure_rgb_inlay.JPG|thumb|400px|left|bottompart + middlepart + pcb ]]  
|}
|}


==Blender Animation of the enclosure==


{{#ev:youtube|i9sB169s1X8}}





Aktuelle Version vom 4. Mai 2011, 04:47 Uhr

< HSC2011

About the enclosure

The enclosure was designed and manufactured by mazzo using Blender and our makerbot "le giraffe"

Files needed for the production of the enclosure




Some screenshots from Blender

The bottom of the EduBuzzer enclosure
The top of the EduBuzzer enclosure
The complete EduBuzzer enclosure
Highlighted Battery holder, on/off switch holder and PCB


Photos of the final enclosure

The enclosure + PCB
The bottom half of the enclosure
Fully assembled!
The middlepart is lazzored and the RGB led shines in there to change the color of the enclosure
middlepart attched to the enclosure
connection on the bottom for the iButton, on/off switch + power
bottompart + middlepart + pcb

Blender Animation of the enclosure

{{#ev:youtube|i9sB169s1X8}}