AVRProgrammers: Unterschied zwischen den Versionen
Keine Bearbeitungszusammenfassung |
|||
| (10 dazwischenliegende Versionen von 2 Benutzern werden nicht angezeigt) | |||
| Zeile 52: | Zeile 52: | ||
= Programmers = | = Programmers = | ||
== RS-232 programmer (ATtiny2313) == | |||
[[Bild:avrprog-rs232.jpg|thumb|200px|RS-232 (ATTiny2313) programmer]] | |||
This programmer has a DB-9 serial port in one end and a 10-pin ISP header in the other end. | This programmer has a DB-9 serial port in one end and a 10-pin ISP header in the other end. | ||
| Zeile 75: | Zeile 75: | ||
== USBasp programmer (stripboard) == | == USBasp programmer (stripboard) == | ||
[[Bild:avrprog-usbasp.jpg|thumb|200px|USBasp stripboard programmer]] | |||
This is a USB programmer built on a stripboard. It has a USB-B connector in one end an a 10-pin ISP header in the other end. | This is a USB programmer built on a stripboard. It has a USB-B connector in one end an a 10-pin ISP header in the other end. | ||
| Zeile 89: | Zeile 91: | ||
avrdude -c usbasp -p atmega168 -U flash:w:ATmegaBOOT_168_ng.hex:i -U lock:w:0x0f:m | avrdude -c usbasp -p atmega168 -U flash:w:ATmegaBOOT_168_ng.hex:i -U lock:w:0x0f:m | ||
== [[ | == [[Avrprog-metaboard]] == | ||
[[Bild:avrprog-metaboard.jpg|thumb|200px|Metaboard AVRprog programmer]] | |||
A [[Metaboard]]-based programmer. | A [[Metaboard]]-based programmer. | ||
| Zeile 102: | Zeile 106: | ||
Note: This programmer has a bootloader on it, so it can be updated over USB. There is a jumper to enable the bootloader. This jumper must be '''off''' when using it as a programmer and '''on''' when accessing the bootloader. | Note: This programmer has a bootloader on it, so it can be updated over USB. There is a jumper to enable the bootloader. This jumper must be '''off''' when using it as a programmer and '''on''' when accessing the bootloader. | ||
[[ | == [http://www.ladyada.net/make/usbtinyisp USBTinyISP] == | ||
The USBTinyISP from Lady Ada. | |||
FIXME: Safe vs. unsafe | |||
Check connection: | |||
avrdude -c usbtiny -p atmega168 | |||
== Any Arduino Board == | |||
see [[Benutzer:Mihi/Programming-attiny45-mit-arduino]] | |||
= Troubleshooting = | |||
Sometimes, the following happens: | |||
<tt> | |||
avrdude: erasing chip<br/> | |||
avrdude: error: programm enable: target doesn't answer. 1 | |||
</tt> | |||
This has shown to be caused by wrong crystal fuse settings, typically an issue when programming fresh chips. | |||
To fix, program all fuses first, before erasing the chip. | |||
[[Kategorie:Arduino]] | [[Kategorie:Arduino]] | ||