3DPrinter/Manual: Unterschied zwischen den Versionen
Zoff99 (Diskussion | Beiträge) |
Pete (Diskussion | Beiträge) |
||
| (3 dazwischenliegende Versionen von 2 Benutzern werden nicht angezeigt) | |||
| Zeile 111: | Zeile 111: | ||
then visit: https://www.prusa3d.com/drivers/ | then visit: https://www.prusa3d.com/drivers/ | ||
and select "Original Prusa i3 | and select "Original Prusa i3 MK2.5S" | ||
then under "Firmware 3.A.B (1.X.Y)" | then under "Firmware 3.A.B (1.X.Y)" | ||
| Zeile 117: | Zeile 117: | ||
save the zip file to your computer (it will be called something like: | save the zip file to your computer (it will be called something like: prusa3d_fw_?_?_?_MK25S.zip) | ||
it does contain the firmwares for the printer | it does contain the firmwares for the printer! ( we don't have the MMU module installed anymore ) | ||
now unpack the zip file. | now unpack the zip file. | ||
| Zeile 130: | Zeile 130: | ||
use this file (with RAMBo13a in the name): | use this file (with RAMBo13a in the name): | ||
" | "prusa3d_fw_MK25S_?_?_?_????_RAMBo13a_en-de.hex" | ||
install PrusaSlicer and follow the instructions to flash the file on this page: | install PrusaSlicer and follow the instructions to flash the file on this page: | ||
| Zeile 140: | Zeile 140: | ||
Updating firmware using PrusaSlicer | Updating firmware using PrusaSlicer | ||
in some cases you need to run PrusaSlicer as *root*, or the USB device will not work properly! | |||
<b>PrusaSlicer will detect the USB-connected printer even when it is powered off, but in order to upgrade the firmware, the printer has to be powered on!</b> | |||