GoCNC: Unterschied zwischen den Versionen

@@ Zeile 7: / Zeile 7: @@
 * Steppers are set to 1.5A, 8 Microsteps
+** It uses a Stepp2500a control board
+** Steppers are Nanotec ST5618X1008-B 4.9V 1.0A
 * Maximum working Plane: X165, Y290, Z65
-* Maximum Speed: 1000mm/min - better use 800mm/min
+* Maximum Speed: around 1000mm/min
 * For use with Dremel or Proxxon Device as spindle
+* It uses M10 threaded rods, which are quite bad...
 == Configuration ==