Laser/Experiments: Unterschied zwischen den Versionen
aus Metalab Wiki, dem offenen Zentrum für meta-disziplinäre Magier und technisch-kreative Enthusiasten.
Zur Navigation springenZur Suche springen
K (verschob „Lazzzor/Experiments“ nach „Laser/Experiments“) |
Keine Bearbeitungszusammenfassung |
||
| Zeile 26: | Zeile 26: | ||
** using color mapping for different speed/power/frequency in one job.. | ** using color mapping for different speed/power/frequency in one job.. | ||
[[Category:Lazzzor]] | [[Category:Lazzzor]] | ||
[[Category:English]] | [[Category:English]] | ||
Version vom 27. Januar 2013, 02:17 Uhr
about
This section explores different possibilities of parameters and their outcome. This is a good place to get you an idea on how to fine tune your parameters.
Material:
- The material
- different parameters 1
- different parameters 2
- different parameters 3
- Soap
- engraving a soap ended in the soap swelling, or so I’ve heard.
- Leather
- Got a 1,5mm raw dark-brown leather, cutting goes incredible good, but on one side it goes better then on the other. Speed: 45, Power: 100, Freq.: 2500
- Engraving is not soo good, you can see the engraved parts, but only on 100/100, and then its not even black or something... May this depends on your leather
- Thin felt (knorrprandel Bogen 1mm)
- Speed 100%
- Power 10%
- Pulse frequency 2500Hz
ideas
- making a example raster / vector file for experimental cuts
- using color mapping for different speed/power/frequency in one job..
