C64DTV: Unterschied zwischen den Versionen

(3 dazwischenliegende Versionen von einem anderen Benutzer werden nicht angezeigt)

Zeile 38:

== Connectors ==

I have fitted the connectors onto the casing of the joystick, using a dremel and a glue gun (NB! no gaffa was used in this project :).

I have fitted the connectors onto the casing of the joystick, using a dremel and a glue gun (NB! no gaffa was used in this project :)).

Connectors, seen from the front:

Zeile 91:

== Connecting to the PCB ==

~~[[Bild:solderpoints.png|left|thumb|200px|soldering points on PCB]]~~

All soldering should be done on the backside of the PCB. Note that some soldering points are located under the rubber buttons. For flexibility, I built internal connectors to easier be able to disconnect and debug the connectors.

[[Bild:internal1.png|thumb|200px|Keyboard && disk connectors]]

{|

[[Bild:internal2.png|thumb|200px|Joystick connectors]]

|[[Bild:solderpoints.png|thumb|200px|soldering points on PCB]]

[[Bild:internal3.png|thumb|200px|PCB with connectors]]

|[[Bild:internal1.png|thumb|200px|Keyboard && disk connectors]]

|-

|[[Bild:internal2.png|thumb|200px|Joystick connectors]]

|[[Bild:internal3.png|thumb|200px|PCB with connectors]]

|}

<p>

Zeile 106:

Zeile 109:

{|

|[[Bild:regulator_schem.png|200px|regulator schematics]]

|-

|[[Bild:regulator.png|200px|+5V voltage regulator]]

|-

|[[Bild:regulator_conn.png|200px|regulator connection]]

|}

Zeile 119:

Zeile 122:

* Reprogram the built-in flash memory with an updated game collection

* Add a memory card reader which supports reading disk images stored on a CF/SD/XD/USB-stick/whatever memory card.

For comments, questions, ideas etc., contact [[Benutzer:MariusKintel|Marius]]

[[Kategorie:WhateverLab]]

[[Kategorie:~~RetroGaming~~]]

[[Kategorie:Projekte]]